Description
120PCS Solder Seal Wire Connectors, Heat Shrink Butt Connector Waterproof Insulated Electrical Butt Terminals Wire Splice for Automotive Marine Boat Truck Trailer Wiring
Specification:
- Shrinkage ratio is 2:1
- Temperature that start to shrink: 80℃
- Temperature that solder ring start to melt: 111˚C
- Temperature that solder ring melt completely：138˚C
- Note: It means the temperature of surface of the connector, rather than the temperature that the hot air gun should set.
How to use:
- 1.Strip the two wires that going to connect and select the right size of connector.
- 2.Thread the connector to one of the wires and then twist the two conductor together.
- 3.Move the connector to the middle of the conductor.
- 4.Apply heat to the connector slowly and evenly with a hot air gun with nozzle until it melt with the wire.
Note:
- Some of our customers can use lighter to finish the joint, but we recommend that it is better to use a heat gun with nozzle to heat shrink the connector.
- Please rotate the wire when you are heating or surround the wire to heat so that the tube was heated evenly.
- 3-5 cm (1.18-1.96 inch) is the suitable distance we recommend from the nozzle to the connectors.
- Package Include:
- 1.30 x White Connectors: Diameter 1.7 mm, able cross-section 0.25-0.34 mm²(A.W.G.:26-24);
- 2.40 x Red Connectors: Diameter 2.7 mm, Cable cross-section 0.5-1.0 mm²(A.W.G.:22-18);
- 3.40 x Blue Connectors: Diameter 4.5 mm, Cable cross-section 1.5-2.5 mm²(A.W.G.:16-14);
- 4.10 x Yellow Connectors: Diameter 6.0 mm, Cable cross-section 4.0-6.0 mm²(A.W.G.:12-10).
Package includes:
- 1 x 120PCS Solder Seal Wire Connectors